7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Boot options
Description
This command configures an uplinkB static route.
Parameters
ip-address
Specifies the IP address of the BOF. This address must be unique within the subnet and
specified in dotted-decimal notation.
Values a.b.c.d
mask
Specifies the subnet mask length when the IP prefix is specified in CIDR notation. When
the IP prefix is specified in CIDR notation, a forward slash (/) separates the ip-address
from the mask parameter. The mask parameter indicates the number of bits used for the
network portion of the IP address. The remainder of the IP address is used to determine
the host portion of the IP address.
Values 0 to 32
next-hop ip-address
Specifies the next-hop IP address used to reach the destination.
uplinkA-speed
Syntax
uplinkA-speed speed
Context
bof
Platforms
7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE, 7210 SAS-Sx 10/100GE, 7210 SAS-T (network mode and
access-uplink mode)
Description
This command configures the speed for the uplinkA port when auto-negotiation is disabled in the running
configuration and the BOF.
If the port is configured to auto-negotiate, this parameter is ignored.
Note:
The uplinkA-autoneg command is not valid for 10gig ports. Therefore, whenever the user
selects 10gig ports as uplinkA-port, the uplinkA-autoneg command is defaulted to no uplinkA-
autoneg, speed as uplinkA-speed 10000, duplex as uplinkA-duplex full, as shown in the
following output example.
#uplinkA Port Settings:
uplinkA-port 1/1/26
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
200
SPACER TEXT
To Next Page
Loading...