EasyManua.ls Logo

Nokia 7210 SAS-Mxp - Page 252

Nokia 7210 SAS-Mxp
736 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Table 28: Over-temperature threshold for 7210 SAS devices
Device variants Minimum temperature
(in degrees centigrade)
Maximum temperature
(in degrees centigrade)
7210 SAS-Mxp 0 76
7210 SAS-Mxp ETR -10 80
7210 SAS-R6 -1 74
7210 SAS-R12 0 96
7210 SAS-Sx/S 1/10GE and
7210 SAS-Sx 10/100GE
0 85
7210 SAS-T 0 58
7210 SAS-T ETR -21 68
The 7210 SAS system software controls the fans by monitoring the internal temperature of the chassis.
The software manages the fan speed to maintain the internal temperature within operational limits.
The 7210 SAS-R6 supports overheat protection reboot. This feature protects the IMM and CPM cards
when the temperature exceeds system-defined temperature thresholds; these thresholds are not user-
configurable. The software monitors the temperature of each card and if the temperature exceeds the
threshold, the system raises an over-temperature critical event. The system reboots all overheated CPM
cards and powers off all overheated IMM cards to reduce the heat generated, which consequently cools
down the chassis. The system powers back on the IMM cards after the temperature is reduced. Operators
are still required to take immediate action for an over-temperature critical event. See the 7210 SAS-R6
Chassis Installation Guide for more information about maintaining the operating temperature.
Note:
Nokia recommends that when planning their availability design, operators must consider CPM
card reboot handling that is caused when the system temperature exceeds system-defined
thresholds. Failure to build in network redundancy may result in network and service downtime.
6.3.1 Synchronization
This section describes the synchronization between the CPMs or CFMs.
6.3.1.1 Configuration and boot-env synchronization
Configuration and boot-env synchronization are supported in the admin>redundancy>synchronize and
config>redundancy>synchronize contexts.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
252
SPACER TEXT

Table of Contents

Related product manuals