7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Example
The following output is an example of information displayed during a manual synchronization of
configuration files.
A:ALA-12>admin>redundancy# synchronize config
Syncing configuration......
Syncing configuration.....Completed.
A:ALA-12#
6.4.1 Active and standby designations on 7210 SAS-R6 and 7210 SAS-R12
Typically, the first Switch Fabric (SF) or CPM card installed in a redundant 7210 SAS-R6 and 7210 SAS-
R12 chassis assumes the active CPM role, regardless of whether it is inserted in slot A or B. The next
CPM installed in the same chassis then assumes the standby CPM role. If two CPMs are inserted
simultaneously (or almost simultaneously) and boot at the same time, preference is given to the CPM
installed in slot A.
If only one CPM is installed in a redundant 7210 SAS-R6 and 7210 SAS-R12, it becomes the active CPM
regardless of the slot it is installed in.
To visually determine the active and standby designations, the Status LED on the faceplate is lit green
(steady) to indicate the active designation. The Status LED on the second CPM faceplate is lit amber to
indicate the standby designation.
Example
The following output sample shows that the CPM installed in slot A is acting as the active CPM and the
CPM installed in slot B is acting as the standby.
A:7210SASR1# show card
===============================================================================
Card Summary
===============================================================================
Slot Provisioned Type Admin Operational Comments
Equipped Type (if different) State State
-------------------------------------------------------------------------------
1 imm-sas-10sfp+1xfp up up
2 imm-sas-10sfp+1xfp up up
A cpm-sf-sas-R6 up up/active
B cpm-sf-sas-R6 up up/standby
===============================================================================
A:7210SASR1#
The following console message is displayed if a CPM boots, detects an active CPM, and assumes the role
of the standby CPM.
...
Slot A contains the Active CPM
This CPM (slot B) is the standby CPM.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
254
SPACER TEXT
To Next Page
Loading...