EasyManua.ls Logo

Nokia 7210 SAS-Mxp - Page 270

Nokia 7210 SAS-Mxp
736 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
includes a localPriority parameter, and includes the ability to force a port to never enter the timeReceiver
state (master-only). The precedence is as follows:
clock class
clock accuracy
PTP variance (offsetScaledLogVariance)
priority2
localPriority
clock identity
steps removed from the grandmaster
The 7210 SAS sets its local parameters as described in the following table.
Table 36: Local clock parameters when profile is set to g8275dot1-2014
Parameter Value
clockClass 165 – the 7210 SAS is configured as a boundary clock and
the boundary clock was previously locked to a grandmaster
with clock class of 6
248 – the 7210 SAS is configured as a boundary clock
255 – the 7210 SAS is configured as an ordinary clock time
Receiver
clockAccuracy FE – unknown
offsetScaledLogVariance FFFF – not computed
clockIdentity Chassis MAC address following the guidelines of section
7.5.2.2.2 of IEEE 1588-2008
The 7210 SAS supports a limited number of configured (possible timeTransmitter or neighbor boundary
clocks) and a discovered peers (timeReceivers).These peers use the unicast negotiation procedures
to request service from the 7210 SAS clock. A neighbor boundary clock counts as two peers (both a
configured and a discovered peer) toward the maximum limit.
The number of configured Ethernet ports is not restricted.
On the 7210 SAS-Mxp, 7210 SAS-R6, 7210 SAS-R12, 7210 SAS-Sx 1/10GE, 7210 SAS-Sx 10/100GE
64SFP+ 4QSFP28, and 7210 SAS-T, there are limits on the number of timeReceivers enforced in the
implementation for unicast and multicast timeReceivers.
Note:
Contact a Nokia technical support representative for scaling information about specific unicast
message limits related to PTP.
The following figure shows the unicast negotiation procedure performed between a timeReceiver and
a timeTransmitter clock that is selected to be the timeReceiver clock. The timeReceiver clock requests
Announce messages from all peer clocks, but only requests Sync and Delay_Resp messages from the
clock selected to be the timeTransmitter clock.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
270
SPACER TEXT

Table of Contents

Related product manuals