Nokia 7210 SAS-Mxp - Page 294

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
6.14.1.1 System information parameters
This section describes the system information parameters.
6.14.1.1.1 Name
Use the system name command to configure a name for the device. The name is used in the prompt
string. Only one system name can be configured. If multiple system names are configured, the last one
encountered overwrites the previous entry.
Use the following CLI syntax to configure the system name.
config>system
name <system-name>
Example: Command usage
config>system# name ALA-12
Example: System name configuration
sysName@domain>config>system# info
#------------------------------------------
echo "System Configuration "
#------------------------------------------
name "ALA-12"
. . .
exit
----------------------------------------------
sysName@domain>config>system#
6.14.1.1.2 Contact
Use the contact command to specify the name of a system administrator, IT staff member, or other
administrative entity.
Use the following syntax to specify the contact name.
config>system
contact <contact-name>
Example: Command usage to specify the contact name
config>system# contact ‟Fred Information Technology”
6.14.1.1.3 Location
Use the location command to specify the system location of the device. For example, enter the city,
building address, floor, and room number where the router is located.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
294
SPACER TEXT