7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
CLI usage
Command Description
terminal Configures the terminal screen length for the current CLI
session.
time-display Specifies whether time should be displayed in local time or UTC.
2.2.4 CLI monitor commands
Monitor commands display specified statistical information related to the monitor subject (such as filter,
port, QoS, router, service) at a configurable interval until a count is reached. The CLI monitor commands
are found in the root>monitor context of the CLI tree.
The monitor command output displays a snapshot of the current statistics. The output display refreshes
with subsequent statistical information at each configured interval and is displayed as a delta to the
previous display.
The <Ctrl-c> keystroke interrupts a monitoring process. Monitor command configurations cannot be
saved. You must enter the command for each monitoring session. Note that if the maximum limits are
configured, you can monitor the statistical information for a maximum of 60 * 999 sec ~ 1000 minutes.
The CLI monitor command are described in the following table.
Table 8: CLI monitor command contexts
Command Description
filter Enables IP, IPv6 and MAC filter monitoring at a configurable
interval until that count is reached.
lag Enables Link Aggregation Group (LAG) monitoring to display
statistics for individual port members and the LAG.
port Enables port traffic monitoring. The specified ports statistical
information displays at the configured interval until the
configured count is reached.
router Enables virtual router instance monitoring at a configurable
interval until that count is reached.
service Monitors commands for a particular service.
2.3 Getting help in the CLI
The help system commands and the ? key display different types of help in the CLI. The following table
describes the different help commands.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
32
SPACER TEXT
To Next Page
Loading...