Nokia 7210 SAS-Mxp - Page 366

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Specifies the controller card to be of type passive 1830 VWM CWDM controller.
ec-dw
Specifies the controller type to be passive 1830 VWM DWDM controller.
ec-dwa
Specifies the controller type to be active 1830 VWM DWDM controller.
Note:
• The vwm-shelf-id can take values in the range 1 to 7. This implies that
the rotary switch on the connected optical clip-on device must be set to a
value in this range.
• For management of DWDM using the 7210 SAS-T, 7210 SAS-R6,
and 7210 SAS-R12 through OMC interface, the main shelf (that is,
the first shelf) to which the node is connected should have EC-DWA.
If connected through OMC interface, the shelf ID can be 1 to 7 and if
connected through USB interface, the shelf ID should be 0.
• If the main shelf has any other shelf ID (that is, 1 to 7), the shelf will not
become operational.
create
Keyword to create the vwm-shelf-id.
card
Syntax
card card-id
Context
config>system>vwm-shelf
Platforms
7210 SAS-T (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6 and 7210 SAS-R12
Description
Commands in this context provision the information for the modules that can be plugged into the slots on
the 1830 VWM clip-on device.
This command provides the user better control over the modules plugged into the 1830 CWDM device
slots. The user can preprovision acceptable modules by configuring the card-type parameter with the
appropriate vwm-acronym. Modules are identified using the card type acronyms listed in Table 41: Card
type acronyms for 1830 CWDM devices and Table 42: Card type acronyms for 1830 DWDM devices.
The no form of this command removes the configured card ID and the software forgets all the information
it has for the card. The software will not raise any events/traps/alarms for the card and clear all pending
events/traps/alarms/LEDs.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
366
SPACER TEXT