Nokia 7210 SAS-Mxp - Page 506

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
The no form of this command removes the allocated resources for use by G.8032.The entire resource pool
is available for use by ACLs. The no form of this command takes affect only on reboot.
Default
no g8032-fast-flood-enable
decommission
Syntax
decommission
Context
config>system>resource-profile
Platforms
7210 SAS-T (network and access-uplink)
Description
Commands in this context decommission a port. Ports which are decommissioned using this command
are not available for provisioning services. The packet buffers are taken away from the decommissioned
port and allocated to port(s) as specified by the entries configured under the decommission command.
This command allocates more packet buffers to a certain port or group of ports and enables those ports to
absorb larger bursts.
entry
Syntax
entry entry-id port port-range to port-range
no entry entry-id
Context
config>system>resource-profile>decommission
Platforms
7210 SAS-T (network and access-uplink)
Description
This command decommissions a port or group of ports and allocates buffers to ports that need more
packet buffers for absorbing larger bursts. It allows the user to configure the entries which list the ports
to be decommissioned. Ports whose packet buffers are taken away are given on the left-hand of the to
keyword, and ports to which buffers are allocated to are given on the right-hand side.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
506
SPACER TEXT