7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Platforms
Supported on all 7210 SAS platforms as described in this document, including platforms configured in the
access-uplink operating mode
Description
This command allocates maximum resources for use by egress filter policies using ipv6 criteria with 128-bit
IPv6 addresses.
The resources cannot be shared with any other egress filter policies that specify other match criteria. See
the 7210 SAS-Mxp, R6, R12, S, Sx, T Router Configuration Guide for more information about resource
allocation and fields available for use.
The no form of this command specifies that the software does not allocate any resources for use by egress
filter policies using ipv6 criteria with 128-bit IPv6 addresses. If no resources are allocated for use, the
software fails all attempts to associate a service entity (for example, SAP and IP interface) with a filter
policy using this match criteria.
Default
no ipv6-128bit-match-enable
Parameters
num-resources
Specifies the maximum amount of resources for use by this filter match criteria. A minimum
value of 2 (indicating two chunks of resources) must be allocated to use this match-
criteria. If not, association of a policy with ipv6-128bit criteria to a SAP will fail. It is mutually
exclusive to use of SAP egress aggregate meter.
Values The following table lists the parameter values.
Table 44: Number of resources available for ipv6-128bit-match-enable
Platforms Min value
(per node)
Max value
(per node)
Default
values
7210 SAS-T access-uplink mode (per node) 0 2 0
7210 SAS-T network mode (per node) 0 2 0
7210 SAS-Sx 1/10GE (standalone) 0 2 0
7210 SAS-Sx 1/10GE (standalone-VC) 0 2 0
7210 SAS-S 1/10GE (standalone) 0 2 0
7210 SAS-S 1/10GE (standalone-VC) 0 2 0
7210 SAS-Sx 10/100GE 0 2 0
7210 SAS-Mxp 0 2 0
7210 SAS-R6 and 7210 SAS-R12 (per IMM) 0 2 0
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
513
SPACER TEXT
To Next Page
Loading...