7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
ldp-ecmp
Syntax
ldp-ecmp percent-value
no ldp-ecmp
Context
configure>system>resource-profile>router
configure>system>global-res-profile>router
Platforms
Supported on all 7210 SAS platforms as described in this document
Description
Note:
The configure>system>resource-profile context is supported on the 7210 SAS-T, 7210 SAS-
Mxp, 7210 SAS-Sx/S 1/10GE: standalone, and 7210 SAS-Sx 10/100GE.
The configure>system>global-res-profile context is supported on the 7210 SAS-R6,
7210 SAS-R12, and 7210 SAS-Sx/S 1/10GE: standalone-VC.
This command enables LDP ECMP and configures the percentage of the total amount of hardware ECMP
resources to be allocated for use by LDP ECMP FECs.
The remaining amount of resources are allocated for use by IP ECMP. In other words, the hardware ECMP
resources are shared by IP ECMP and LDP ECMP and this command allow user to allocate resources to
them.
The no form disables LDP ECMP (by allocating zero resources to it) and the system installs only a single
next-hop for every LDP FEC.
Note:
On 7210 SAS-R6 and 7210 SAS-R12, it is a system wide limit, applicable to all IMMs. If the user
changes this value dynamically, the system adjusts the usage among IP and LDP ECMP as per
the configuration.
The user can change the value of resources allocated towards IP ECMP routes and LDP ECMP FECs
without requiring a reboot of the node as long as the following conditions are met. The configure system
resource-profile router ldp-ecmp command cannot be modified until the value of the configure router
ecmp command is set to 1. It is similar to the behavior available for the configure system resource-
profile router ecmp command. The value cannot be changed until the value of the configure router
ecmp command is set to 1.
Default
no ldp-ecmp
Parameters
percent-value
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
556
SPACER TEXT
To Next Page
Loading...