Nokia 7210 SAS-Mxp - Page 57

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
CLI usage
Keyword to perform a syntax check of the file without executing the commands. Syntax
checking finds invalid commands and keywords, but it will not be able to validate
erroneous user-configured parameters.
Default Execute file commands.
file-name
The text file with CLI commands to execute.
<<
Stdin can be used as the source of commands for the exec command. When stdin is used
as the exec command input, the command list is terminated with Ctrl-C, ‟EOF<Return>” or
‟eof_string<Return>”.
If an error occurs entering an exec file sourced from stdin, all commands after the
command returning the error will be silently ignored. The exec command will indicate the
command error line number when the stdin input is terminated with an end-of-file input.
eof_string
Specifies the ASCII printable string used to indicate the end of the exec file when stdin is
used as the exec file source. Ctrl-C and ‟EOF” can always be used to terminate an exec
file sourced from stdin.
Default Ctrl-C, EOF
exit
Syntax
exit [all]
Context
<GLOBAL>
Platforms
Supported on all 7210 SAS platforms as described in this document, including those operating in access-
uplink mode
Description
This command returns to the context from which the current level was entered. For example, if you
navigated to the current level on a context by context basis, then the exit command only moves the cursor
back one level.
A:Dut-G# configure
A:Dut-G>config# service
A:Dut-G>config>service# vpls 1
A:Dut-G>config>service>vpls# exit
A:Dut-G>config>service# exit
A:Dut-G>config# exit
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
57
SPACER TEXT