Nokia 7210 SAS-Mxp - Page 593

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
oper-group
Syntax
oper-group [group-name]
oper-group group-name [detail]
oper-group group-name [monitoring]
Context
show>system
Platforms
Supported only on 7210 SAS platforms configured in the access-uplink operating mode
Description
This command displays oper-group information, member count, monitor-client count, and status in a single
line for each of the configured oper-groups.
Output
The following output is an example of oper-group information, and Table 71: Output fields: oper-group
describes the output fields.
Show Output
*A:7210SAS>show>system# oper-group
===============================================================================
System Oper Group Information
===============================================================================
Name Oper Creation Hold Hold Members Monitor
Status Origin UpTime DnTime
(secs) (secs)
-------------------------------------------------------------------------------
test up manual 4 0 1 1
-------------------------------------------------------------------------------
Entries found: 1
===============================================================================
*A:7210SAS>show>system#
*A:7210SAS>show>system# oper-group test monitoring
===============================================================================
System Oper Group Information
===============================================================================
Oper Group : test
Creation Origin : manual Oper Status : up
Hold DownTime : 0 secs Hold UpTime : 4 secs
Members : 0 Monitoring : 0
===============================================================================
*A:7210SAS>show>system#
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
593
SPACER TEXT