Nokia 7210 SAS-Mxp - Page 664

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
System management
Label Description
Power supply number The ID for each power supply installed in the chassis
Configured power supply
type
The power supply type that is configured
AC power Within range — AC voltage is within range
Out of range — AC voltage is out of range
DC power Within range — DC voltage is within range
Out of range — DC voltage is out of range
Over temp Within range — The current temperature is within the
acceptable range
Out of range — The current temperature is above the
acceptable range
Status Up — The specified power supply is up
Down — The specified power supply is down
alarm-contact-input
Syntax
alarm-contact-input all
Context
show>alarm-contact-input
Platforms
7210 SAS-T (network and access-uplink), 7210 SAS-Mxp, 7210 SAS-R6, and, 7210 SAS-R12
Description
This command displays information of all the alarm contact input pins.
Output
The following output is an example of alarm contact input information, and Table 93: Output fields: alarm
contact input describes the output fields.
Sample output
*A:7210-2# show alarm-contact-input 1
===============================================================================
Alarm Contact Input
===============================================================================
Alarm Input Pin Number : 1
Alarm Input Pin Current State : Disabled
Alarm Output Pin Used : Major
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
664
SPACER TEXT