7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
CLI usage
monitor>management-access-filter
Platforms
Supported on all 7210 SAS platforms as described in this document, including those operating in access-
uplink mode
Description
This command enables IPv6 filter monitoring. The statistical information for the specified IPv6 filter entry
displays at the configured interval until the configured count is reached.
The first screen displays the current statistics related to the specified IPv6 filter. The subsequent statistical
information listed for each interval is displayed as a delta to the previous display.
When the keyword rate is specified, the rate per second for each statistic is displayed instead of the delta.
Monitor commands are similar to show commands but only statistical information displays. Monitor
commands display the selected statistics according to the configured number of times at the interval
specified.
Parameters
iv6p-filter-id
Displays detailed information for the specified IPv6 filter ID and its filter entries.
Values 1 to 65535
entry entry-id
Displays information on the specified IPv6 filter entry ID for the specified filter ID only.
Values 1 to 65535
interval seconds
Specifies the interval for each display in seconds.
Default 10 seconds
Values 3 to 60
repeat repeat
Specifies how many times the command is repeated.
Default 10
Values 1 to 999
absolute
Keyword to display the raw statistics, without processing. No calculations are performed on
the delta or rate statistics.
rate
Keyword to display the rate per second for each statistic instead of the delta.
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
81
SPACER TEXT
To Next Page
Loading...