CIBANO 500 PTM User Manual
118 OMICRON
17 Off-service diagnostic methods
This section describes off-service testing of circuit breakers with CIBANO 500 and its accessories.
Primary Test Manager in combination with CIBANO 500 supports the following off-service tests:
• Contact Resistance
• Timing
• Dynamic Contact Resistance
• Minimum Pickup
• Motor Current
• Insulation Resistance
• Timing (CSM)
• Demagnetization
The tests are grouped according to their application areas in:
• 17.1 "Testing medium-voltage circuit breakers" on page 119
• 17.2 "Testing high-voltage circuit breakers" on page 163
• 17.3 "Testing gas insulated switchgears with both sides grounded" on page 214
• 17.4 "Demagnetization" on page 246
• 17.5 "Testing circuit breakers with CIBANO 500 and the CB TN3 modules" on page 252
Note: You can configure the tests in different ways as described earlier in this User Manual. For
conciseness, the wording open the test in the application procedures means clicking the test in the
Primary Test Manager workspace independently of how the test has been configured.
To Next Page
Loading...
