OMICRON 57
Create new guided jobs
► To load the location data available in Primary Test Manager, click Load existing location on the
ribbon, and then select the location you want to load in the Select Location dialog box.
Figure 7-5: Select Location dialog box
In the Select Location dialog box, you can search for locations (see 10.1 "Search for objects" on
page 78).
7.3.1 Location data
The following table describes the location data.
Table 7-6: Location data
Data Description
Name
1
Name of the location where the asset is located
Region Region where the asset is located
Division Division where the asset is located
Area Area where the asset is located
Plant Plant where the asset is located
Address Address of the location where the asset is located
City City where the asset is located
State/Province State or province where the asset is located
Postal code Postal code of the location where the asset is located
Country Country where the asset is located
Geo coordinates Geo coordinates of the location where the asset is located
(see 7.3.2 "Setting the geo coordinates" later in this section)