81
Functions of General-purpose Slaves and Environment-resistive Slaves Section 4-3
Manual Recovery Mode Recovery occurs when the wiring is corrected and the I/O power supply is
turned back ON.
I/O Indicator Status when Disconnection is Detected
Setting Using the
DeviceNet
Configurator
The method used to set values from the DeviceNet Configurator (Ver. 2.20 or
later) is described here.
1,2,3... 1. Turn ON the power to the DRT2-series Smart Slave.
2. From the Main Window, open the Network Configuration Window and dou-
ble-click or click the right mouse button over the icon of the DRT2-series
Smart Slave to be set. Select Parameter and Edit to display the Edit De-
vice Parameters Window.
From the Maintenance Mode Window, click the right mouse button over the
icon of the DRT2-series Smart Slave to be set. Select Parameter and Edit
to display the Edit Device Parameters Window.
3. Select the IN Tab.
0 to 15
Flashing
red.
To Next Page
Loading...
Need help?
General
