11
DRT2 Slaves Section 1-2
1-2-4 Smart Slave Feature Support
Yes: Supported.; No: Not supported.
Note 1. The Operation Time Monitor cannot be used with the DRT2-@D08(-1).
2. The DRT2-@D08(-1) and DRT2-MD16(-1) cannot be expanded with an Ex-
pansion Unit.
3. The Contact Operation Counter and Total ON Time Monitor cannot be
used at the same time for the same contact.
Type General-purpose Slaves
Remote I/O Terminals
Standard Relay
outputs
3-tier terminal block
Feature Input Output Mix Output Input Output Mix
Operation Time Monitor Yes (for inputs + outputs only) (See note
1.)
Ye s
Contact Operation Counter Yes
Unit ON Time Monitor Yes
Total ON Time Monitor Yes
Naming Units Yes
Naming connected devices Yes
Network Power Voltage Monitor Yes
I/O Power Status Monitor Yes No Yes
Communications Error History Monitor Yes
Input filter Yes No Yes No Yes No Yes
Preventing malfunctions caused by inrush
current at startup
Ye s N o Ye s N o Ye s N o Ye s
Sensor power short-circuit detection No
Sensor disconnected detection No
External load short-circuit detection No
External load disconnected detection No
Detachable terminal block construction Yes
Automatic baud rate detection Yes
Power supply wiring not required for Units Yes
Power supply wiring not required for input
devices
No Yes No No No
Expansion using Expansion Units Yes (See note 2.) No No No
Scaling No
User adjustment No
Last maintenance date Yes
Cumulative counter No
Moving average No
Setting the number of AD conversion points No
Peak/bottom hold No
Top/ val l ey h o l d No
Rate of change No
Comparator No
Communications error output No
To Next Page
Loading...
Need help?
General
