12
DRT2 Slaves Section 1-2
Yes: Supported.; No: Not supported.
Note The Contact Operation Counter and Total ON Time Monitor cannot be used at
the same time for the same contact.
Type General-purpose Slaves
Sensor Connector Terminals
Sensor connectors MIL connectors
(Board Terminals)
Feature Input Mix Input Output Mix
Operation Time Monitor No Yes Yes
Contact Operation Counter Yes
Unit ON Time Monitor Yes
Total ON Time Monitor Yes
Naming Units Yes
Naming connected devices Yes
Network Power Voltage Monitor Yes
I/O Power Status Monitor No Yes
Communications Error History Monitor Yes
Input filter Yes Yes No Yes
Preventing malfunctions caused by inrush current at
startup
Ye s Ye s N o Ye s
Sensor power short-circuit detection Yes No
Sensor disconnected detection No
External load short-circuit detection No Yes No
External load disconnected detection No
Detachable terminal block construction No
Automatic baud rate detection Yes
Power supply wiring not required for Units Yes
Power supply wiring not required for input devices Yes No
Expansion using Expansion Units No
Scaling No
User adjustment No
Last maintenance date Yes
Cumulative counter No
Moving average No
Setting the number of AD conversion points No
Peak/bottom hold No
Top/ val l ey h o l d No
Rate of change No
Comparator No
Communications error output No
To Next Page
Loading...
Need help?
General
