98
Remote I/O Terminals with Transistors Section 5-5
Node Address
Settings
The node address of the Remote I/O Terminal is set as a decimal, using the
left rotary switch for the ten's digit, and the right rotary switch for the one's
digit. (Up to 63 nodes can be set.)
Node addresses 64 to 99 can be set from the Configurator, using the following
method.
Note 1. The rotary switch settings are read when the power is turned ON.
2. The rotary switches of the DRT2-@D@@ML(X)(-1) are located on the top
of the Terminal.
Setting Node Addresses Using the DeviceNet Configurator
1,2,3... 1. Select Setup Node Address/Baud rate from the Tools Menu.
2. The following window will be displayed. Input the node address of the Unit
to be changed and the new node address, and then click the Change But-
ton.
0
1
2
3
4
5
6
7
8
9
0
1
2
3
4
5
6
7
8
9
Node address setting (one's
digit)
Node address setting (ten's
digit)
To Next Page
Loading...
Need help?
General
