238
Connecting Communications Cables to Environment-resistive Slaves Section 6-2
Thick Cables with Connectors: Mini-size
Note 1. The boxes in the model numbers indicate the cable length in 1-m units. A
cable of 0.5 m, however, is indicated as “C5.”
2. Standard DeviceNet cables are used for these connections, so the cables
cannot be used in environments subject to spattering, unless measures
are taken to protect the cables.
The following connectors with built-in terminating resistance are also avail-
able. A Terminating Resistor can also be connected to a T-branch Connector.
Model Description
DCA2-5CN@@W1 Cable with shielded connec-
tors on both ends
DCA2-5CN@@F1 Cable with shielded connector
(female socket) on one end
DCA2-5CN@@H1 Cable with shielded connector
(male plug) on one end
DCN3-11 Shielded T-branch Connector
(for one branch line)
DCN3-12 Shielded T-branch Connector
(for one branch line)
An M12 connector is used for
the branch line.
Model Details
DRS2-1 Shielded Connector
(male plug, micro-size) with
terminating resistance.
DRS2-2 Shielded Connector
(female socket, micro-size)
with terminating resistance.
DRS3-1 Shielded Connector
(male plug, mini-size) with ter-
minating resistance.
To Next Page
Loading...
Need help?
General
