14
DRT2 Slaves Section 1-2
Yes: Supported.; No: Not supported.
Note The Contact Operation Counter and Total ON Time Monitor cannot be used at
the same time for the same contact.
Type General-purpose Slaves
Screw-less Clamp Terminals
DRT2-@D32SLH (With detection
function)
DRT2-@D32SL (Without detection
function)
Feature Input Output Mix Input Output Mix
Operation Time Monitor Yes Yes
Contact Operation Counter Yes
Unit ON Time Monitor Yes
Total ON Time Monitor Yes
Naming Units Yes
Naming connected devices Yes
Network Power Voltage Monitor Yes
I/O Power Status Monitor Yes
Communications Error History Monitor Yes
Input filter Yes No Yes Yes No Yes
Preventing malfunctions caused by inrush
current at startup
Ye s N o Ye s Ye s N o Ye s
Sensor power short-circuit detection Yes No Yes No
Sensor disconnected detection Yes No Yes No
External load short-circuit detection No
External load disconnected detection No Yes Yes No
Detachable terminal block construction Yes
Automatic baud rate detection Yes
Power supply wiring not required for Units Yes
Power supply wiring not required for input
devices
No
Expansion using Expansion Units No
Scaling No
User adjustment No
Last maintenance date Yes
Cumulative counter No
Moving average No
Setting the number of AD conversion points No
Peak/bottom hold No
Top/ val l ey h o l d No
Rate of change No
Comparator No
Communications error output No
To Next Page
Loading...
Need help?
General
