16
DRT2 Slaves Section 1-2
Yes: Supported.; No: Not supported.
Note The Contact Operation Counter and Total ON Time Monitor cannot be used at
the same time for the same contact.
Type Analog Slaves
Analog Terminals Temperature
Input
Terminal
DRT2-AD04 DRT2-AD04H DRT2-DA02
Feature Input Output Input
Operation Time Monitor No No No No
Contact Operation Counter No No No No
Unit ON Time Monitor Yes Yes Yes Yes
Total ON Time Monitor No No No No
Naming Units Yes Yes Yes Yes
Naming connected devices Yes Yes Yes Yes
Network Power Voltage Monitor Yes Yes Yes Yes
I/O Power Status Monitor No No No No
Communications Error History Monitor Yes Yes Yes Yes
Input filter No No No No
Preventing malfunctions caused by inrush current at startup No No No No
Sensor power short-circuit detection No No No No
Sensor disconnected detection No No No No
External load short-circuit detection No No No No
External load disconnected detection No No No No
Detachable terminal block construction Yes Yes Yes Yes
Automatic baud rate detection Yes Yes Yes Yes
Power supply wiring not required for Units Yes Yes Yes Yes
Power supply wiring not required for input devices No No No No
Expansion using Expansion Units No No No No
Scaling Yes Yes Yes Yes
User adjustment Yes Yes Yes Yes
Last maintenance date Yes Yes Yes Yes
Cumulative counter Yes Yes Yes Yes
Moving average Yes Yes No Yes
Setting the number of AD conversion points Yes No No No
Peak/bottom hold Yes Yes No Yes
Top/valley hold Yes Yes No Yes
Rate of change Yes Yes No Yes
Comparator Yes Yes No Yes
Communications error output No No Yes No
Top/valley count function No No No Yes
Temperature range timing function No No No Yes
Input temperature variation detection function No No No Yes
To Next Page
Loading...
Need help?
General
