Omron SYSDRIVE 3G3RV Series User Manual

5
-
10
nUser-set Parameters: A2
The parameters set by the user are listed in the following table.
A1-03
Initialize
Used to initialize the param-
eters using the specified
method.
0: No initializing
1110: Initializes using the
Parameters
2220: Initializes using a
two-wire sequence.
(Initializes to the
factory setting.)
3330: Initializes using a
three-wire sequence.
0 to
3330
0 No A A A 103H -
Init Parame-
ters
A1-04
Password
Password input when a pass-
word has been set in A1-05.
This function write-protects
some parameters of the ini-
tialize mode.
If the password is changed,
A1-01 to A1-03 and A2-01
to A2-32 parameters can no
longer be changed. (Pro-
gramming mode parameters
can be changed.)
0 to
9999
0 No A A A 104H 6-141
Enter Pass-
word
A1-05
Password
setting
Used to set a four digit num-
ber as the password.
This parameter is not usually
displayed. When the Pass-
word (A1-04) is displayed,
hold down the RESET Key
and press the Menu Key and
the password will be dis-
played.
0 to
9999
0 No A A A 105H 6-141
Select Pass-
word
Param-
eter
Number
Name
Description
Setting
Range
Factory
Setting
Change
during
Opera-
tion
Control Methods
Regis-
ter
Page
LCD
Display
V/f
V/f
with
PG
Open
Loop
A2-01
to
A2-32
User setting
parameters
Used to set the parameter
numbers that can be set/read.
Maximum 32.
Effective when the Parame-
ter Access Level (A1-01) is
set to User Program (1).
Parameters set in parameters
A2-01 to A2-32 can be set/
read in programming mode.
b1-01
to
o2-08
-NoAAA
106H to
125H
6-142
User Param
1 to 32
Param-
eter
Number
Name
Description
Setting
Range
Factory
Setting
Change
during
Opera-
tion
Control Methods
Register Page
LCD
Display
V/f
V/f
with
PG
Open
Loop

Omron SYSDRIVE 3G3RV Series Specifications

General

Brand	Omron
Model	SYSDRIVE 3G3RV Series
Category	Inverter
Language	English