K
KK
K Drive
Mode
Drive
Mode
is
the
mode
in
which
the
Inverter
can
be
operated.
The
following
monitor
displays
are
possible
in
Drive
Mode:
The
frequency
reference,
output
frequency,
output
current,
and
output
voltage,
as
well
as
fault
information
and
the
fault
history.
When
b1-01
(Reference
selection)
is
set
to
0,
the
frequency
can
be
changed
from
the
frequency
setting
display.
Use
the
Increment,
Decrement,
and
Digit
Selection/RESET
Keys
to
change
the
frequency.
The
parameter
will
be
written
and
the
monitor
display
will
be
returned
to
when
the
ENTER
Key
is
pressed
after
changing
the
set-
ting.
nExample
Operations
Key
operations
in
Drive
Mode
are
shown
in
the
following
figure.
Fig 3.4 Operations in Drive Mode (Example for the 3G3IV-PJVOP161)
IMPORTANT
The display for the first monitor parameter (frequency reference) will be displayed when power is turned ON.
The monitor item displayed at startup can be set in o1-02 (Monitor Selection after Power Up).
Operation cannot be started from the Mode Selection Display.
Mode Selection Display Monitor Constant Display
Power ONMENU
Drive Mode
DRIVE QUICK
VERIFY
ADV
Detailed Monitor Constant
Display
Monitor Display
ESC
ESC
Status Monitor
Error Trace
Fault History
ESC
Frequency reference
RESET
Fan operating time
ESC
ESC
ESC
RESET
ESC
ESC
ESC
RESET
ESC
ESC
ESC
ESC
ESC
ESC
ESC
ESC
Current error
Operating time at error
1st previous error
ESC
ESC
Frequency reference
Frequency reference setting/
display unit o1-03
Output frequency
Output current
Monitor setting for o1-01
VERIFY
ADVDRIVE QUICK
VERIFY
ADV
DRIVE QUICK
Operating time at 4th
previous error
AUTO
TUNING
AUTO
TUNING
AUTO
TUNING
To Next Page
Loading...
Need help?
General