Omron SYSDRIVE 3G3RV Series

O
ptions and Peripheral Devices
9
-
9


 Separately Installed Options
The separately installed options include Scaling Meters and Analog Operators.
n Scaling Meters
A Scaling Meter is attached to a multi-function analog output from the Inverter and is used to display rota-
tional speeds of motors, line speeds, etc., in physical units.
Models and Application
The standard models of Scaling Meters are listed in the following table.
Note The power supply circuit is isolated from the input circuits.
Standard Specifications
The standard specifications of the Scaling Meters are listed below.
 IP51 requires that theoptional K32-L49SC Drop-proof Cover be used. The protective structure is IP50 without it.
Model No. Control Power Supply Display
K3TJ-V111R
100 to 200 VAC
Red LED
K3TJ-V111G Green LED
K3TJ-V116R
24 VDC, isolated
(See note.)
Red LED
K3TJ-V116G Green LED
K3TJ-V11o
oo
o Specifications
Sampling Period 2 times/s
Display Refresh Cycle 2 times/s
Measurement Averaging Methods Simple average or moving average
Number of Samples for Averaging 1, 2, 4, or 8 samples
Max. No. of Display Digits 4 digits (-1999 to 9999)
Display 7-segment LEDs, character height: 14.2 mm
Decimal Point Display User-set using function selection switch and up/down keys.
Scaling Method
Shifting and scaling are user-set using function selection switch and up/down
keys.
Scaling Range -1999 to 9999
Zero Limit Range 0 to 99 digits
Overrange Values Flashing display
Zero Suppression Supported
External Controls Present value hold (by short-circuiting terminal on front panel)
Protective Structure (conforming to
IEC standards)
Front panel display: IP51
*
Case: IP20
Terminal section: IP00
Memory Protection Non-volatile memory