Omron SYSDRIVE 3G3RV Series

5
-
16
b5-10
PID output
gain
Sets output gain.
0.0 to
25.0
1.0 No A A A 1AEH 6-118
Output Gain
b5-11
PID reverse
output
selection
0: 0 limit when PID output
is negative.
1: Reverses when PID
output is negative.
0 limit when reverse prohibit
is selected using b1-04.
0 or 1 0 No A A A 1AFH 6-118
Output Rev
Sel
b5-12
Selection of
PID feed-
back com-
mand loss
detection
0: No detection of loss of
PID feedback.
1: Detection of loss of PID
feedback.
Operation continues
during detection, with the
malfunctioning contact
not operating.
2: Detection of loss of PID
feedback.
Coasts to stop during
detection, and fault
contact operates.
0 to 2 0 No A A A 1B0H 6-118
Fb los Det
Sel
b5-13
PID feed-
back com-
mand loss
detection
level
Sets the PID feedback loss
detection level as a percent
units, with the maximum
output frequency at 100%.
0 to
100
0% No A A A 1B1H 6-118
Fb los Det
Lvl
b5-14
PID feed-
back com-
mand loss
detection
time
Sets the PID feedback loss
detection level in seconds.
0.0 to
25.5
1.0 s No A A A 1B2H 6-118
Fb los Det
Time
b5-15
PID sleep
function
operation
level
Set the PID sleep function
start level as a frequency.
Always enabled for (-E)
models. On other models, it
is disabled when the PID
control is not selected
(b5-01=0).
0.0 to
400.0
0.0 Hz No A A A 1B3H 6-118
PID Sleep
Level
b5-16
PID sleep
operation
delay time
Set the delay time until the
PID sleep function starts in
seconds.
0.0 to
25.5
0.0 s No A A A 1B4H 6-119
PID Sleep
Time
Param-
eter
Number
Name
Description
Setting
Range
Factory
Setting
Change
during
Opera-
tion
Control Methods
Register Page
LCD
Display
V/f
V/f
with
PG
Open
Loop