Omron SYSDRIVE 3G3RV Series User Manual

5
-
24
*1.The factory setting will change when the control method is changed. (V/f control factory settings are given.)
*2.The starting torque value can be set only for (-E) models.
nSpeed Control (ASR): C5
Parameters for speed control are shown in the following table.
C4-05
Starting
torque time
constant
Sets the rise time constant
(ms) for the starting torque
value.
The filter is disabled if set
between 0 and 4 ms.
0 to
200
10 ms No No No
A
*2
219H 6-37
TorqCmp
Delay T
Param-
eter
Num-
ber
Name
Description
Setting
Range
Factory
Setting
Change
during
Opera-
tion
Control Methods
Register Page
LCD
Display
V/f
V/f
with
PG
Open
Loop
C5-01
ASR pro-
portional
(P) gain 1
Sets the proportional gain of the
speed loop (ASR.)
0.00 to
300.00
0.20 Yes No A No 21BH -
ASR P
Gain 1
C5-02
ASR
integral
(I) time 1
Sets the integral time of the speed
loop (ASR) in 1-second units.
0.000
to
10.000
0.200
s
Yes No A No 21CH -
ASR I
Time 1
C5-03
ASR pro-
portional
(P) gain 2
Usually setting is not necessary.
Set to change the rotational speed
gain.
0.00 to
300.00
0.02 Yes No A No 21DH -
ASR P
Gain 2
C5-04
ASR
integral
(I) time 2
0.000
to
10.000
0.050
s
Yes No A No 21EH -
ASR I
Time 2
C5-05
ASR
limit
Sets the upper limit for the com-
pensation frequency for the speed
control loop (ASR) to a percentage
of the maximum output frequency.
0.0 to
20.0
5.0% No No A No 21FH -
ASR
Limit
Param-
eter
Number
Name
Description
Setting
Range
Factory
Setting
Change
during
Opera-
tion
Control Methods
Register Page
LCD
Display
V/f
V/f
with
PG
Open
Loop
P I
0 E1-04 Motor speed (Hz)
P=C5-01
I=C5-02
P=C5-03
I=C5-04

Omron SYSDRIVE 3G3RV Series Specifications

General

Brand	Omron
Model	SYSDRIVE 3G3RV Series
Category	Inverter
Language	English