Omron SYSDRIVE 3G3RV Series

5
-
44
nCommunications Option Cards: F6
Parameters for a Communications Option Card (DeviceNet) are shown in the following table.
Note For details on Communications Option Cards, refer to the manual for each Option Card (DeviceNet Communications Card/3G3FV-PDRT1-SIN (Cat.
No. I525-E1)).
*1.If F6-01 or F6-03 is set to 3, the Inverter will continue operating. Be sure to install a limit switch or an emergency stop switch as a safety precaution.
*2.For (-E) models.
Param-
eter
Number
Name
Description
Setting
Range
Factory
Setting
Change
during
Opera-
tion
Control Methods
Register Page
LCD
Display
V/f
V/f
with
PG
Open
Loop
F6-01
DeviceNet
fault opera-
tion selec-
tion
0: Decelerates to a stop
using C1-02 deceleration
time/fault detection
1: Coast to a stop/fault
detection
2: Decelerates to stop using
C1-09 deceleration time/
fault detection
3: Continues operating/
alarm detection
*1
0 to 3 1 No A A A 3A2H -
Comm Bus
Flt Sel
F6-02
Communi-
cations
external
fault input
detection
method
selection
0: Fault detection during
power ON
1: Fault detected during
running only (when RUN
commands are input)
0 or 1 0 No A A A 3A3H -
EF0 Detec-
tion
F6-03
Communi-
cations
external
fault input
operation
selection
0: Decelerates to a stop
using C1-02 deceleration
time/fault detection
1: Coast to a stop/fault
detection
2: Decelerates to a stop
using C1-09 deceleration
time/fault detection
3: Continues operating/
alarm detection
*1
0 to 3 1 No A A A 3A4H -
EF0 Fault
Action
F6-04
Not used
Do not set. - 0 No A A A 3A5H -
Trace Sam-
ple Tim
F6-05
Display unit
selection for
current
monitor
0: Amperes
1: 100%/8192
0 or 10 No
A
*2
A
*2
A
*2
3A6H -
Current
Unit Sel