Omron SYSDRIVE 3G3RV Series User Manual

6
-
136
* Factory settings depend on Inverter capacity. (The values shown are for a 200 V Class Inverter for 0.4 kW.)
nChanging Frequency Reference and Display Units
Set the Digital Operator frequency reference and display units using parameter o1-03. You can change the
units for the following parameters using o1-03.
• U1-01 (Frequency Reference)
• U1-02 (Output Frequency)
• U1-05 (Motor Speed)
• U1-20 (Output Frequency after Soft Start)
• d1-01 to d1-17 (Frequency references)
nSwitching Monitors when the Power Supply Is ON
Using parameter o1-02, select the monitor item (U1-oo [status monitor]) to be displayed on the Digital
Operator when the power supply is turned ON. For monitors that can be displayed, refer to U1-oo in Chap-
ter 5 Parameters.
Setting Precautions
If selecting monitor parameters other than U1-01 (Frequency Reference), U1-02 (Output Frequency), and U1-
03 (Output Current), first select the monitor items to be displayed in o1-01, and then set o1-02 to 4.
nDisabling the STOP Key
If b1-02 (Operation Method Selection) is set to 1, 2, or 3, the stop command from the STOP Key on the Digital
Operator is an emergency stop command.
Set o2-02 to 0 to disable emergency stop commands from the STOP Key on the Digital Operator.
nDisabling the LOCAL/REMOTE Key
Set o2-01 to 0 to disable the LOCAL/REMOTE Key on the Digital Operator. You cannot switch Inverter ref-
erence inputs set using reference inputs from the Digital Operator, b1-01 (Reference Selection), or b1-02
(Operation Method Selection).
o2-05
Frequency reference set-
ting method selection
Sets the operation when the Digital Operator is
disconnected.
0: Enter key needed
1: Enter key not needed
Inverter output is cut off, and fault contact is
operated.)
0 or 10 NoAAA
Operator M.O.P.
o2-07
Cumulative operation time
setting
Sets the cumulative operation time in hour units.
Operation time is calculated from the set values.
0 to
65535
0NoAAA
Elapsed Time Set
o2-10
Fan operation time setting Set the initial value of the fan operation time using
time units.
The operation time accumulates from the set
value.
0 to
65535
0NoAAA
Fan ON Time Set
Param-
eter
Num-
ber
Name
Description
Setting
Range
Factory
Setting
Change
during
Opera-
tion
Control Methods
V/f
V/f
with
PG
Open
Loop
Vec-
tor
LCD Display

Omron SYSDRIVE 3G3RV Series Specifications

General

Brand	Omron
Model	SYSDRIVE 3G3RV Series
Category	Inverter
Language	English