3. Return the server to operation.
a. Install the server top cover.
See Install the Server Top Cover.
b. Return the server to the normal rack position.
See Return the Server to the Normal Rack Position.
c. Reconnect the power cords to the server power supplies, and power on the
server.
See Reconnect Power and Data Cables and Power On the Server.
d. Verify that the System OK LED indicator is lit.
Note:
If the service processor is configured to synchronize with a network
time server using the Network Time Protocol (NTP), the Oracle ILOM
SP clock is reset as soon as the server is powered on and
connected to the network. Otherwise, proceed to the next step.
4. If the service processor is not configured to use NTP, you must do one of the
following:
• Reset the Oracle ILOM clock using Oracle ILOM CLI or web interface. Refer to
Oracle ILOM Documentation.
• Use the BIOS Setup Utility to reprogram the host clock. See BIOS Setup Utility
Menus.
Chapter 10
Install the Battery
10-6
To Next Page
Loading...
Need help?
General
