h. Remove the fan tray from the server.
See Remove the Fan Tray.
2. Disconnect the SAS cables from the disk backplane [1].
Press and hold the button on the connector to disengage the locking mechanism,
then gently pull the connector from the disk backplane.
3. Disconnect the SAS cables from the Broadcom 9500-16i, 12GB SAS PCIe, 16
Port, Internal card in PCIe slot 9 [2].
Press each latch, and then pull out to disengage the cable from each connector.
4. Remove the SAS cables from the server [3].
Carefully remove the SAS cable bundles from the server. Be careful not to snag
the cables on the server components.
Install SAS Storage Drive Cables
1. Install the SAS cables between the disk backplane and the rear PCIe slots [1].
Route the SAS cable bundle through the left-side cable trough.
Chapter 16
Install SAS Storage Drive Cables
16-2
To Next Page
Loading...
