4. Use a Torx T15 screwdriver to turn the release button latch counter-clockwise to the
locked position.
Remove Antistatic Measures
• Remove any antistatic straps or conductors from the server chassis.
Reinstall the Server Into the Rack
After servicing the system, reinstall it into the rack.
Caution:
Deploy any rack anti-tilt mechanisms before installing the server into the rack.
Caution:
The server weighs approximately 76 lbs (34 kg). Two people are required to carry
the chassis and install it in the rack.
Use a mechanical lift or two people to transport the chassis and install it in the rack.
Chapter 17
Remove Antistatic Measures
17-3
To Next Page
Loading...
