Oracle Exadata X10M - Remove the Pcie Flyover Cable

Callout Description
1 PCIe Flyover cable
2 PCIe slot 7 electrical interface connector
3 PCIe slot 6 electrical interface connector
4. Install the connector in the desired slot and press down on the connector until it is fully
seated in the slot [2].
5. Continue by installing the PCIe card or Riser 6.
See Install a Half Height PCIe Card or Install a PCIe Riser.
Remove the PCIe Flyover Cable
Before removing the PCIe Flyover cable, review the rules for configuring the PCIe electrical
interfaces. See Configure PCIe Electrical Interfaces Using the PCIe Flyover Cable.
1. Prepare the server for service.
a. Power off the server.
See Powering Down the Server.
b. Disconnect the power cords from the power supplies.
Chapter 11
Remove the PCIe Flyover Cable
11-13