5. Close the drive latch to lock the drive in place.
Power On an NVMe Storage Drive and Attach a Device Driver
• To power on the slot and attach the device driver, type:
# echo 1 > /sys/bus/pci/slots/$slot/power
Where $slot is the slot number for the NVMe storage drive.
Verify Operation of an NVMe Storage Drive
• To verify that an NVMe drive is operating properly, do one of the following:
• Check the /var/log/messages log file.
• Type: ls -l /dev/nvme*
Chapter 4
Removing and Replacing Storage Drives Using an OS
4-8
To Next Page
Loading...
