3
Preparing for Service
This section describes safety considerations and provides prerequisite procedures and
information about replacing components in the server.
Before replacing server components, perform the procedures in the following sections.
Safety Precautions
For your protection, observe the following safety precautions when setting up your
equipment:
• Follow all standard cautions, warnings, and instructions marked on the equipment and
described in the Oracle Server Safety and Compliance Guide and Important Safety
Information for Oracle's Hardware Systems.
• Ensure that the voltage and frequency of your power source match the voltage and
frequency that appear on the equipment electrical rating label.
• Follow the electrostatic discharge safety practices as described in Electrostatic Discharge
Safety.
• Disconnect both power supply cords (if necessary) before servicing components.
Note:
Power cords must be disconnected when servicing components that require
cold service.
Safety Symbols
The following symbols might appear in this document. Note their meanings.
Caution:
Risk of personal injury or equipment damage. To avoid personal injury or
equipment damage, follow the instructions.
Caution:
Hot surface. Avoid contact. Surfaces are hot and might cause personal injury if
touched.
3-1
To Next Page
Loading...
