Oracle Exadata X10M - Reset the Server Using Oracle ILOM; Log out of Oracle ILOM; Mouse Mode Properties

Table 2-11 Mouse Mode Properties
Operating Systems Mouse Mode
Oracle Linux Absolute
Oracle VM Not applicable
VMware ESXi Software Not applicable
Windows Server Absolute
For more information about selecting a mouse mode, refer to Oracle ILOM
Administrator's Guide for Configuration and Maintenance in Oracle ILOM
Documentation.
To set the mouse mode, perform the following steps:
1. Log in to the Oracle ILOM web interface.
See Log In to Oracle ILOM Using a Remote Ethernet Connection.
2. Navigate to the Remote Control → KVMS page, and then select a mouse mode
from the Mouse Mode drop-down list.
3. Click Save.
Reset the Server Using Oracle ILOM
For more details, see Controlling System Power and Oracle ILOM Documentation.
1. Log in to the Oracle ILOM web interface or command-line interface (CLI) using an
account with admin (a) role privileges.
2. Reset the server:
• From Oracle ILOM CLI, type: -> reset /System. When prompted, type y
to confirm:
Are you sure you want to reset /System (y/n)? y
Performing hard reset on /System
• From Oracle ILOM web interface, select Host Management → Power
Control, and in the Select Action list box, select Graceful Reset, Reset,
or Power On. Click Save, and then click OK.
• From the local server, press the On/Standby button on the front panel of the
server for approximately 1 second to power off the server, and then press the
On/Standby button again to power on the server.
The power-on self-test (POST) sequence begins.
Log Out of Oracle ILOM
See the following procedure to log out of Oracle ILOM CLI or web interface.
• To end an Oracle ILOM session:
• From the Oracle ILOM CLI – Type exit at the CLI prompt.
Chapter 2
Accessing Oracle ILOM
2-24