This action causes ACPI-enabled operating systems to perform an orderly
shutdown of the operating system. Servers not running ACPI-enabled operating
systems shut down to Standby power mode immediately.
When main power is off, the System OK LED on the front panel begins blinking,
indicating that the server is in Standby power mode. See System-Level Status
Indicators.
2. Disconnect the power cords and data cables from the server.
See Disconnect Cables From the Server.
Caution:
When you power down the server using the On/Standby button, the
server enters Standby power mode. Power is still directed to the service
processor and power supply fans. To completely power off the server,
you must disconnect the power cords from the power supplies.
Power Down the Server for Immediate Shutdown Using Oracle ILOM CLI
Caution:
An immediate power-off might corrupt system data, therefore, use this
procedure to power down the server only after attempting the graceful power
down procedure.
1. Log in to the Oracle ILOM command-line interface (CLI) using an Administrator
account.
See Accessing Oracle ILOM.
Oracle ILOM displays the default command prompt (->), indicating that you have
successfully logged in to Oracle ILOM.
2. At the CLI prompt, type the following command:
-> stop -f /System
The server powers down immediately to Standby power mode.
3. Disconnect the power and data cables from the server.
See Disconnect Cables From the Server.
Caution:
When you power down the server using Oracle ILOM, the server enters
Standby power mode. Power is still directed to the service processor and
power supply fans. To completely power off the server, you must
disconnect the power cords from the power supplies.
Chapter 3
Preparing the Server for Component Replacement
3-6
To Next Page
Loading...
Need help?
General
