Caution:
Always load equipment into a rack from the bottom up so that the rack does
not become top-heavy and tip over. Extend the rack anti-tilt bar to prevent
the rack from tipping during equipment installation.
1. Ensure that there is at least two rack units (2U) of vertical space in the rack
cabinet to install the server. See Rack Compatibility.
2. Place the Rackmounting Template against the front rails, and measure up from the
bottom of the Rackmounting Template. The bottom edge of the Rackmounting
Template card corresponds to the bottom edge of the server.
Appendix C
Rackmounting the Server
C-10
To Next Page
Loading...
