Oracle Exadata X10M - Page 4

Test the IPv4 or IPv6 Network Configuration 2-21
Set the Mouse Mode 2-23
Reset the Server Using Oracle ILOM 2-24
Log Out of Oracle ILOM 2-24
Monitoring Component Health and Faults Using Oracle ILOM 2-25
Getting Help 2-25
Contacting Support 2-26
Locating the Chassis Serial Number 2-26
Auto Service Requests 2-27
3
Preparing for Service
Safety Precautions 3-1
Safety Symbols 3-1
Electrostatic Discharge Safety 3-2
FRU Key Identity Properties (KIP) Automated Update 3-2
Required Service Tools 3-3
Preparing the Server for Component Replacement 3-3
Powering Down the Server 3-4
Power Down the Server Gracefully Using Oracle ILOM CLI 3-4
Power Down the Server Gracefully Using Oracle ILOM Web Interface 3-5
Power Down the Server Gracefully Using the On/Standby Button 3-5
Power Down the Server for Immediate Shutdown Using Oracle ILOM CLI 3-6
Power Down the Server for Immediate Shutdown Using Oracle ILOM Web
Interface 3-7
Power Down the Server for Immediate Shutdown Using the On/Standby Button 3-7
Disconnect Cables From the Server 3-8
Extend the Server to the Maintenance Position 3-8
Remove the Server From the Rack 3-9
Take Antistatic Measures 3-10
Remove the Server Top Cover 3-11
4
Servicing Storage Drives
Storage Drive Hot-Plug Conditions 4-1
Storage Drive Failure and RAID 4-1
Remove a Storage Drive 4-2
Install a Storage Drive 4-4
Removing and Replacing Storage Drives Using an OS 4-5
Removing and Replacing an NVMe Storage Drive Using Oracle Linux 4-5
Unmount an NVMe Storage Drive 4-5
Remove an NVMe Storage Drive 4-6
iv