4. In T
oolbox, select Ladder elements>Coil and drag the mouse until "Add output or jump
here" is displayed in the main pane.
When you drag the mouse until the position of "Add output or jump here" is reached, the
display of "Add output or jump here" turns green.
When you stop dragging the mouse at the position of Add output or jump here, a coil will be
placed in the network (circuit).
5. Select "???
" of the coil and enter variable bCoil0, and then press the <Enter> key.
The "Auto Declare" dialog box will be displayed.
6. Click the [OK] button.
V
ariable bCoil0 will be declared in the declaration section.
7.1 Programming in Ladder Diagram (LD)
WUME-GM1RTXOP-01 7-5
To Next Page
Loading...
