Panasonic GM1 - Page 431

* A round circle can be specified by omitting an end point or entering the same coordinates for
the start point and end point as below
. (For center point specification only)
[Setting example 2] (When end point is omitted)
G-code setting example:
N03 G17
N04 G02 X100 Y0 I50 J0 F100 E1 E-1
[Setting example 3] (When start point = end point)
G-code setting example:
N03 G17
N04 G02 X0 Y0 I50 J0 F100 E1 E-1
● Explanation of G-code
N03: An XY
-plane is selected.
N04: Circular interpolation is performed in the XY-plane according to the following values.
Current value (X0, Y0), end point (X0, Y0 or omitted)
Center point (X50, Y0)
Velocity 100
Acceleration 1 [u/sec
2
], deceleration -1 [u/sec
2
]
* Circular interpolation can be specified with a radius instead of a center point, as below.
[Setting example 1]
G-code setting example:
N03 G17
N04 G02 X100 Y0 R50 F100 E1 E-1
11.5 Multi-axis Operation
WUME-GM1RTXOP-01 11-69