Panasonic GM1 - Page 432

● Explanation of G-code
N03: An XY
-plane is selected.
N04: Circular interpolation is performed in the XY-plane according to the following values.
Current value (X0, Y0), end point (X100, Y0)
Radius 50
Velocity 100
Acceleration 1 [u/sec
2
], deceleration -1 [u/sec
2
]
● Circular interpolation (XZ-plane)
The following is an setting example of circular interpolation using an XZ-plane.
[Setting example 4]
G-code setting example:
N1
1 G18
N12 G02 X100 Z0 I50 K0 F100 E1 E-1
• Explanation of G-code
N1
1: An XZ-plane is selected.
N12: Circular interpolation is performed in the XZ-plane according to the following values.
Current value (X0, Z0), end point (X100, Z0)
Center point (X50, Z0)
Velocity 100
Acceleration 1 [u/sec
2
], deceleration -1 [u/sec
2
]
● YZ-plane
The following is an setting example of circular interpolation using an YZ-plane.
11.5 Multi-axis Operation
11-70 WUME-GM1RTXOP-01