Name Icon Function
Localization] and then [Manage Localizations] from the
[Project] menu.
Commit accepted changes
Commits the difference between the objects compared by
selecting the
[Project] > [Compare] from the menu bar.
Insert Network
Inserts an empty network.
Toggle network comment state Changes the comment status of the selected network.
Insert Assignment
Inserts a new assignment in the specified position.
Insert Coil Inserts a coil in the specified position.
Insert Set Coil Inserts a set coil in the specified position.
Insert Reset Coil
Inserts a reset coil in the specified position.
Insert Contact Inserts a normally open contact in the specified position.
Insert Negated Contact Inserts a normally closed contact in the specified position.
Insert Contact (right)
Inserts a normally open contact on the right side of the
specified position.
Insert Contact Parallel (below)
Inserts a normally open contact below and in parallel with
the contact at the specified position.
Insert Negated Contact Parallel
(below)
Inserts a normally closed contact below and in parallel with
the contact at the specified position.
Insert Contact Parallel (above)
Inserts a normally open contact above and in parallel with
the contact at the specified position.
Insert Box
Opens the Input Assistant to insert a box in the specified
position.
Insert Empty Box Inserts an empty box in the specified position.
Insert Box with EN/ENO
Opens the Input Assistant to insert a box with EN/ENO in
the specified position.
Insert Empty Box with EN/ENO
Inserts a box with EN/ENO in the specified position.
3.4 Component Names
3-20 WUME-GM1RTXOP-01
To Next Page
Loading...
