Timing chart
■
Sampling capture function (continuous operation)
●
Each time the specified sampling time elapses after the capture flag turns ON or OFF,
successively, the count value is stored in the capture 0 value and capture 1 value registers
and the differential value is stored in the capture differential value register.
● The sampling capture function is always executable when the control 0 signal is allocated to
the sampling capture function.
● The trigger condition that starts sampling capture can be selected from control 0 signal
(positive logic), control 0 signal (negative logic), and capture enable request bit (positive
logic).
● For continuous operation, the capture 0 status bit is activated. Note that the capture 1 status
bit is not activated.
12.6 High-speed Counter Function
WUME-GM1RTXOP-01 12-55
To Next Page
Loading...
