Panasonic KX-NS1000 - Page 1143

Maintenance Console Location
27.8 Router Configuration—Firewall—[2-2] Packet Filtering
Filter—TCP/UDP Source Port—Protocol Name
Selects the protocol type.
If ICMP is selected for Protocol Number—Protocol Name, this item is grayed out.
Note
If ICMP is selected for Protocol Number—Protocol Name or Protocol Name is not selected for TCP/
UDP Source Port, this item is grayed out.
Default
Depends on the value selected for Filter—Protocol Number—Protocol Name:
• TCP or TCP&UDP is selected: FTP
• UDP is selected: DNS
Value Range
If TCP is selected for Protocol Number—Protocol Name, the following protocol types can be selected:
FTP(20/21), SSH(22), Telnet(23), HTTP(80), HTTPS(443), POP3(110), POS3S(995), IMAP(143), SMTP(25)
If UDP is selected for Protocol Number—Protocol Name, the following protocol types can be selected:
DNS(53), DHCP(67/68), TFTP(69), SNMP(161/162)
If TCP&UDP
is selected for Protocol Number—Protocol Name, the following protocol types can be selected:
FTP(20/21), SSH(22), Telnet(23), HTTP(80), HTTPS(443), POP3(110), POS3S(995), IMAP(143), SMTP(25),
DNS(53), DHCP(67/68), TFTP(69), SNMP(161/162)
Maintenance Console Location
27.8 Router Configuration—Firewall—[2-2] Packet Filtering
Filter—TCP/UDP Source Port—Port Number
Specifies the start and end port numbers.
If ICMP is selected for Protocol Number—Protocol Name, this item is grayed out.
Default
0
Value Range
0–65535
Maintenance Console Location
27.8 Router Configuration
—Firewall—[2-2] Packet Filtering
Filter—TCP/UDP Destination Port
Selects the method of specifying the TCP/UDP Destination Port.
If ICMP is selected for Protocol Number—Protocol Name, this item is grayed out.
Document Version 2016-03 PC Programming Manual 1143
27.8 Router Configuration—Firewall—[2-2] Packet Filtering