Panasonic KX-NS1000 - Page 1144

Default
ANY
Value Range
ANY, Protocol Name, Port Number
Maintenance Console Location
27.8 Router Configuration
—Firewall—[2-2] Packet Filtering
Filter—TCP/UDP Destination Port—Protocol Name
Selects the protocol type.
If ICMP is selected for Protocol Number—Protocol Name, or Protocol Name is selected for TCP/UDP
Destination Port, this item is grayed out.
Default
Depends on the value selected for Filter—Protocol Number—Protocol Name:
• TCP or TCP&UDP is selected: FTP
• UDP is selected: DNS
Value Range
If TCP is selected for Protocol Number—Protocol Name, the following protocol types can be selected:
FTP(20/21), SSH(22), Telnet(23), HTTP(80), HTTPS(443), POP3(110), POS3S(995), IMAP(143), SMTP(25)
If UDP is selected for Protocol Number—Protocol Name, the following protocol types can be selected:
DNS(53), DHCP(67/68), TFTP(69), SNMP(161/162)
If TCP&UDP
is selected for Protocol Number—Protocol Name, the following protocol types can be selected:
FTP(20/21), SSH(22), Telnet(23), HTTP(80), HTTPS(443), POP3(110), POS3S(995), IMAP(143), SMTP(25),
DNS(53), DHCP(67/68), TFTP(69), SNMP(161/162)
Maintenance Console Location
27.8 Router Configuration—Firewall—[2-2] Packet Filtering
Filter—TCP/UDP Destination Port—Port Number
Specifies the start and end port number.
If ICMP is selected for Protocol Number—Protocol Name, this item is grayed out.
Default
0
Value Range
0–65535
Maintenance Console Location
27.8 Router Configuration
—Firewall—[2-2] Packet Filtering
1144 PC Programming Manual Document Version 2016-03
27.8 Router Configuration—Firewall—[2-2] Packet Filtering