P-Preferred-Identity Header—SIP-URI
Specifies the complete SIP-URI address of the P-Preferred
-Identity header. The configuration in
P-Preferred-Identity Header—User Part will be invalid if this parameter is set.
Default
Not stored
Value Range
Max. 100 characters
Maintenance Console Location
9.11 PBX Configuration—[1-1] Configuration—Slot—V-SIPGW—Port Property
Number Format
Selects the format of the CLIP number to be sent to the called party.
Default
National
Value Range
International, +International
, National
Maintenance Console Location
9.11 PBX Configuration—[1-1] Configuration—Slot—V-SIPGW—Port Property
Remove Digit
Specifies the number of leading digits of the CLIP number to be removed. This setting is compulsory when
PBX-CLIP is selected in From Header—User Part or P-Preferred-Identity Header—User Part.
Default
0
Value Range
0–32
Maintenance Console Location
9.11 PBX Configuration
—[1-1] Configuration—Slot—V-SIPGW—Port Property
Additional Dial
Specifies the number to be added to the CLIP number in the place of the removed digits. This setting is
compulsory
when PBX-CLIP is selected in From Header—User Part or P-Preferred-Identity Header—User
Part.
Default
Not stored
314 PC Programming Manual Document Version 2016-03
9.11 PBX Configuration—[1-1] Configuration—Slot—V-SIPGW—Port Property
To Next Page
Loading...
