Panasonic KX-NS1000 - 5.1.4 Time Service

Value Range
630 ms, 830 ms, 1030 ms
Maintenance Console Location
9.24 PBX Configuration
—[1-1] Configuration—Slot—Card Property - LCO type
Low Speed Pulse Dial—Pulse % Break
Specifies
the % break for a low speed pulse dial. This is the ratio between the break (on-hook) signal and make
(off-hook) signal in a pulse dial.
Default
60%
Value Range
Other, 60%, 67%
Maintenance Console Location
9.24 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
Programming Manual References
9.25 PBX Configuration—[1-1] Configuration—Slot—Port Property - LCO Port
Low Speed Pulse Dial—Break Width
Specifies
the maximum length of the break signal in a low speed pulse dial.
Low Speed Pulse Dial—
Pulse
% Break on this screen determines the value that can be specified here.
Default
60 ms
Value Range
20 + (4 ´ n) (n=1–15) ms
Maintenance Console Location
9.24 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
Programming Manual References
9.25 PBX Configuration—[1-1] Configuration—Slot—Port Property - LCO Port
Low Speed Pulse Dial—Make Width
Specifies the minimum length of the make signal in a low speed pulse dial. Low Speed Pulse Dial—Pulse
% Break on this screen determines the value that can be specified here.
Document Version 2016-03 PC Programming Manual 431
9.24 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type