Panasonic KX-NS1000 - Page 432

Default
40 ms
Value Range
4 ´ n (n=3–15) ms
Maintenance Console Location
9.24 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
Programming Manual References
9.25 PBX Configuration—[1-1] Configuration—Slot—Port Property - LCO Port
High Speed Pulse Dial—Pulse % Break
Specifies the % break for a high speed pulse dial. This is the ratio between the break
(on-hook) signal and
make (off-hook) signal in a pulse dial.
Default
60 %
Value Range
Other, 60 %, 67 %
Maintenance Console Location
9.24 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
Programming Manual References
9.25 PBX Configuration—[1-1] Configuration—Slot—Port Property - LCO Port
High Speed Pulse Dial—Break Width
Specifies
the maximum length of the break signal in a high speed pulse dial.
High Speed Pulse Dial—Pulse
% Break on this screen determines the value that can be specified here.
Default
32 ms
Value Range
12+ (4 ´ n) (n=1–15) ms
Maintenance Console Location
9.24 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type
Programming Manual References
9.25 PBX Configuration—[1-1] Configuration—Slot—Port Property - LCO Port
432 PC Programming Manual Document Version 2016-03
9.24 PBX Configuration—[1-1] Configuration—Slot—Card Property - LCO type